This page is for architects, designers and specification writers.
It produces the documents for a project manual: the guide specification (Section 14 27 00), a finish schedule and product data sheets, filled in with the configuration and finishes you select.
Choosing finishes for your own elevator and looking for pricing? Use the standard finish selector on any Fusion configuration page instead.
Write CabCraft into your project specification.
The Spec Writer produces the documents a project manual needs: Section 14 27 00 Custom Elevator Cab Interiors, a finish schedule and product data sheets, filled in with the configuration and finishes you select. Three steps, nothing pre-selected, no account required.
An architect, interior designer, elevator consultant or specification writer preparing construction documents for new construction or an elevator modernization. You will leave with an editable spec section, a finish schedule and data sheets written to your selections.
Building owners, property managers and elevator contractors should use the finish selector on any Fusion configuration page: pick finishes on the numbered rendering, review the spec sheet and send it to CabCraft for renderings and pricing. Open the finish selector →
Everything for the project manual, in one place.
Section 14 27 00 in Word, the finish schedule in Excel and the configuration data sheet, each written to your selections. About ten minutes, nothing pre-selected, no account required.
Pick a configuration, specify finishes, download the documents.
Pick a configuration
Fourteen Fusion panel layouts, each available in any panel face material. Or describe a custom layout to us.
Browse configurationsSpecify finishes
Tap a numbered component on the rendering, pick a finish. Select from our standards or enter any product from your preferred vendor; we confirm it meets code.
Start with step 1Download your completed documents
Everything is generated with your selections written in: Section 14 27 00 in Word, the finish schedule in Excel, the configuration data sheet and a spec sheet PDF. Or send the set straight to CabCraft for renderings and pricing.
Start with step 1You design it. We make sure it fits, meets code and goes in fast.
Any finish, any manufacturer
Our standard laminates, metals, glass and stone are a starting point. Specify any material from any vendor that meets the code requirements for elevator interiors; we confirm compliance and the substrate before fabrication.
Code review on every job
Materials comply with ASME A17.1 for car enclosures. Installed weight is checked against the elevator contractor's allowance; interior replacement on an existing car is coordinated with the alteration requirements.
Installed in about a day
Every package is prefabricated and pre-fit to the cab's dimensions and shipped ready to install, by CabCraft Interiors or a qualified elevator contractor.
Talk to us before the section is issued.
Code review, weight allowances, preferred-vendor finishes and custom layouts: send the question and we reply with an answer, usually the same day.